Today we are going to replace the fog light bulb in the VW Jetta to H11 led bulb. We’re gonna start by removing four 25 bolts here and at the end do you get the front bumper off. Start by removing these t25 bolts from the bottom and necks trigger to move the t25 bolts that are located inside the fender well. We’re gonna do the same on the other side of the vehicle. If you need to take off your front bumper, there is a guide along the back of this bumper. So you’re gonna want to apply some pressure forward to get out of the guide and then it’s all going to come straight out to finish removing the front bumper.
If your vehicle is equipped with fog lights, you want to grab this simply twist and pop it out and do the same on the other side. There are two t25 screws, just remove them on the bottom of your foglight, you will find the adjuster. As there is a hole in the front of the bumper, put a socket through and adjuster headlight to aim for the road to put the fog light back into the bumper.
We’re going to take your fog light with the adjuster down, these two alignment female slots on the bumper, hold it in place, grab your t25 bolt to place the bumper back in.
When your bumper is still lightly connected by the center and the side is still disconnected, you’re gonna take your fog light bulb, place it in and twist it back into its lock position. Do the same for the other side, to place the bumper back onto the brackets which have clips all along the top, make it sure it’s aligned underneath the headlight. Press it back into place to reinstall the hardware into the bumper, the liner actually attaches to the other screws that go into the bumper to attach the liner back to the bumper.
That you’re gonna want to get before the skirt and then to put the liner back in. You’re gonna want to fold this over and then put your 3t 25 volts back into place, if you reconnect the shield back up to the car. You’re starting from one side back into place and the last step you want to take the remainder of your t25 bolts and line up your grill on the top and screw it down it should be all set.
If you are interested in the led bulb that I use in this article, you can find them by this link: